MakerBot Replicator 2x Manuale Utente Scaricare il pdf (Pagina 9)

Page 8

Rev.2

B. Prepare the printer & Check for Damages

Use a brush to clean out leftover plastic bits inside and around the printer.

Clean off the build surface and make sure there is no damage to the print

surface (no tears, cuts, or rips in the Kapton tape), and no buildup of plastic on

the printer heads (this should look like plastic globs, or bits covering the

nozzle). If there is plastic protruding from the tip of either nozzle, use the

provided tweezers to carefully remove it.

DO NOT USE ANY METAL ON THE KAPTON TAPE

C. Turn the printer on

Make sure the printer is plugged in, and then turn the printer on by pressing

the toggle switch on the rear corner of the unit. When the lights come on, the

printer is ready for the next step.

Figure 3 - Printer Heads

Figure 4 - Power Switch

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Nessun commento

MakerBot Replicator 2x Manuale Utente Pagina 9