MakerBot Replicator 2x Manuale Utente Pagina 6
- Pagina / 20
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
Page 5
Rev.2
C. Setting the Print Options
To set the print options, select Make and a popup window will appear. In the
3D printing lab, there are only Replicator 2X printers, so this option should
already be selected.
(To see a list of standard options, see Appendix B)
There are only a few important options that need to be focused on, these are
the options that will largely affect part quality and print time.
Resolution:
- Low: This is the fastest option for printing, but isn’t very high quality
- Standard: This is a mix between higher quality and lower print speed
- High: This is the highest quality quick option, but it is very slow
Raft:
This is an option to print out a build surface, this is good when flatness is
important, or to reduce part warping.
Options: Off or Color-Matched.
Protip: Rafts can be hard to remove from printed parts. To remove the rafts
more easily, allow the part to fully cool before separating it. If problems
persist, freezing the part before removing the raft might work, but the part
will become brittle while cool.
Supports:
This option is for support material. Supports are important on large
overhangs and open holes in vertical geometry. Supports are generally not
needed unless large overhangs, bridges, or holes exist in the part.
Options: Off or Color-Matched.
Infill:
Infill is the percentage of internal part geometry that is filled with build
material. It is important to have the infill at a high enough percentage to
- Rapid Prototyping with the 1
- MakerBot Replicator 2X 1
- Table of Contents 2
- Converting your part 3
- A. MakerWare Basics 4
- B. Importing your part 5
- C. Setting the Print Options 6
- Printing the Part 8
- C. Turn the printer on 9
- D. Level the build plate 10
- E. Lower Build Plate 11
- F. Load Filament 11
- G. Preheat (Optional) 12
- PART IS LIFTING! 13
- Part has separated! 13
- J. Removing Your Part 14
- L. Cool Down (Optional) 15
- M. Post-Build Cleanup 16
- N. Final Teardown and Checks 16
- Page 16 17
- Rev.2 17
- Page 17 18
- ☑ (Check Box) 19
- Appendix C – References 20
- Works Cited 20
Prodotti e manuali riguardandi Stampa e scansione MakerBot Replicator 2x
(4 pagine)JBL BassProTM II manuali
Manuali dei proprietari e guide per l'utente per Microfoni JBL BassProTM II.
We fornisce 1 manuali pdf JBL BassProTM II per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Commenti su questo manuale