MakerBot Replicator 2x Manuale Utente Scaricare il pdf (Pagina 16)

Page 15

Rev.2

M. Post-Build Cleanup

After printing parts, the MakerBot will need to be cleaned for the next user.

A simple checklist can be followed to quickly and efficiently clean the printer:

1. Clean the build platform with the paintbrush

2. Clean around the build platform with the paintbrush

3. Clean off the work bench with the bench brush

4. Use tweezers to carefully remove any plastic hanging down from the

extruder nozzle.

N. Final Teardown and Checks

Remove the spool from the back of the printer and put it back where it is

stored. Remove the SD card and turn off the printer.

Check inside and outside the printer for damages and report to a Lab Assistant

or email mecl@purdue.edu if there are any.

Remember: Safety is important and even the safest equipment can become

dangerous if guidelines are not followed!

Final Check:

1. Did you unload the filament?

2. Did you remove the SD card?

3. Did you turn off the printer?

4. Did you check for damages?

5. Did you clean the printer?

Figure 14 - Teardown

1 2 ... 11 12 13 14 15 16 17 18 19 20

Nessun commento

MakerBot Replicator 2x Manuale Utente Pagina 16