MakerBot Replicator 2x Manuale Utente Scaricare il pdf (Pagina 8)

Page 7

Rev.2

Preview before printing:

Selecting this option is important since it allows you to check how your part

settings will affect the model and also be able to see what your printed part

will look like. You can use the slider on the left to select different build layers

to look at. Controls in the preview are similar to MakerWare.

Protip: If you want to dial in the best infill, shells, and check on the support

structure, look carefully throughout the layers and think of the plastic as hot

glue being placed on the layer below it, if there is nothing below a layer it

might droop a bit, so a higher infill might fix that problem.

D. Export the Print

After your settings are prepared, select “Export” (click on “Export!” again if

you selected print preview. ) and navigate to where you want to save your file.

Printing the Part

A. Preload an SD card:

Obtain an SD card through the E-Shop (Room 2042) or a Lab Assistant, (unless

you already have one) and move your print file onto the card.

Figure 2 - SD Card and USB Adapter

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Nessun commento

MakerBot Replicator 2x Manuale Utente Pagina 8